Ogee Gutter Internal Angle - 90 Degree x 80mm Black

In stock
Code
RAN1B
From 17 reviews
More Information
Code RAN1B
EAN Code 5055149910173
Angle 90 Degree
Brand FloPlast
Colour Black
Dimension 174mm (W) x 174mm (L) x 97mm (D)
Guarantee 10 Years Manufacturers
Material PVC-u
Specification BS EN 12200 / BS EN 607 / BS EN 1462
Weight (kg) 0.318000
Size 110mm x 80mm
£5.66 £4.72
You need to spend another £250.00 to qualify for 2.5% discount.

Our Ogee Gutter and Fittings are manufactured by UK market leaders FloPlast.

90 degrees ogee gutter angles are used at the corners of the installation. As the Niagara Ogee gutter is not a symmetrical system, these must be ordered as either internal or external. The best way to understand the difference between an internal and an external corner is to view the pictures and remember that the flat side of the fitting always fits against the fascia board. Our article on Buying and Installing Ogee Gutter may also be helpful here. Internal Angles are most often found where two gutters meet at the bottom of a valley. For a quick overview of gutter angles please watch the short video below: 

The guttering should always be supported by a fascia bracket within 150mm (6") of any corner. This is to prevent water from collecting in the fitting, which in turn would cause the gutter angle to drop down, putting stress on the joints and reducing the flow rate.  

You can view a video on how to correctly install FloPlast Gutter systems in our Guides and Tips Section.