Ogee Gutter External Angle - 90 Degree x 80mm White
|Dimension||176mm (W) x 173mm (L) x 96mm (D)|
|Guarantee||20 Years Manufacturers|
|Specification||BS EN 12200 / BS EN 607 / BS EN 1462|
|Size||110mm x 80mm|
Our Ogee Gutter and Fittings are manufactured by UK market leaders FloPlast.
90 degrees ogee gutter angles are used at the corners of the installation. As the Niagara Ogee gutter is not a symmetrical system, these must be ordered as either internal or external. The best way to understand the difference between an internal and an external corner is to view the pictures and remember that the flat side of the fitting always fits against the fascia board. Our article on Buying and Installing Ogee Gutter may also be helpful here. For a quick overview of gutter angles please watch the short video below (1min 12 secs).
The guttering should always be supported by a fascia bracket within 150mm (6") of any corner. This is to prevent water from collecting in the fitting, which in turn would cause the gutter angle to drop down, putting stress on the joints and reducing the flow rate.
You can view a video on how to correctly install FloPlast Gutter systems in our Guides and Tips Section.