FloPlast Cast Iron Effect Ogee Gutter External Stopend Right Hand - 110mm x 80mm - Pack of 2
Click or tap the image to open in fullscreen
| Code | REN2CIPK2 |
|---|---|
| EAN Code | 5056919006614 |
| Weight (kg) | 0.280000 |
| Width | 96mm |
| Angle | 0 |
| Brand | FloPlast |
| Colour | Cast Iron Effect |
| Dimension | 50mm (H) x 134mm (L) x 96mm (W) |
| Pipe Fit | 0 |
| Guarantee | 20 Year |
| Length | 134mm |
| Height (mm) | 50mm |
| Material | PVC-u |
| Pack Size | Pack of 2 |
| Specification | BS EN 12200 / BS EN 607 |
| System Size | 110mm x 80mm |
| Capacity | 0 |
External Stopends are used to cap off the gutter at the end of the run. They are called external because they fit over the outside of the gutter profile. Because ogee is not a symmetrical system, stop ends are handed either right or left - the video below clarifies the difference.
Stopends are fixed to the gutter by clipping the back end into place first, then pulling the gutter gently down inside the front clip. This exerts an even pressure on the rubber seal to make a waterproof joint.
To prevent the end of the gutter from sagging down you should always support a stopend by fixing a fascia bracket within 150mm of the stop end.
You can view our short PBSL Group generic product review below;
This is a pack of two.
