Steel Downpipe Bend - 90 Degree x 87mm Graphite Grey

In stock
Only %1 left
Code
STAL90B90G

Click or tap the image to open in fullscreen

Steel Downpipe Bend - 90 Degree x 87mm Graphite Grey
More Information
Code STAL90B90G
£19.06 £15.88 £23.82 Save 20%
Spend another £1500 to pay over time with Klarna

92.5 Bends are used in a steel guttering system to change the plane of the downpipe bend from vertical to horizontal or vice versa.

They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.

This bend also doubles up as a shoe for the bottom of the downpipe if it is not being connected directly into the drainage system.

The finish on the galvanised 90 Degree bend is very slightly different due to the manufacturing process, although the difference is not noticeable unless used at level.

YOU MAY ALSO LIKE