Cast Iron Round Downpipe Bend - 92.5 Degree x 100mm Primed

In stock
Only %1 left
Code
R4020

Click or tap the image to open in fullscreen

Cast Iron Round Downpipe Bend - 92.5 Degree x 100mm Primed
More Information
Code R4020
£40.52 £33.77 £23.57
Spend another £1500 to pay over time with Klarna

92.5 Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa.

They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.

The angle of the bend is 92.5 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.

YOU MAY ALSO LIKE